정기적으로 검사 the 노화 문제 of 폭발 방지 열 이동 오일 히터

During normal use, regular inspections should be conducted on the electric heating pipes of explosion-proof heat transfer oil heaters, mainly focusing on some electrical connections, including the tightness of the connection ends between the site and the factory. If aging problems are found, timely repair and maintenance should be carried out. To avoid leakage issues. If rust is found on the shell or interface of the explosion-proof heat transfer oil heater electric heating pipe during use, the power should be cut off and the rust should be wiped clean before use. When the explosion-proof heat transfer oil heater electric heating pipe is installed in some lower temperature situations, safety measures should be taken before use to prevent the medium from freezing and expanding, which may damage the equipment.
To use the explosion-proof heat transfer oil heater electric heating pipe, it is necessary to follow the relevant procedures, first connect the air source, and wait until the gas volume requirements are met and the flow rate is stable before the explosion-proof heat transfer oil heater electric heating pipe can be energized. If the gas flow suddenly stops during use, the power should be immediately cut off. In normal times, it is necessary to regular inspect the various equipment of the explosion-proof thermal oil heater electric heating pipe and determine 여부 the 절연 layer is intact. 만약 the 전기 난방 파이프 의 방폭 열 이송 오일 히터 is 손상된, for safety reasons, it is better to replace it with a new one for use. If maintenance is necessary, special attention should also be paid to the maintenance 방법 회피 원인 위험.